Hypertherm HTA Rev 6.00 Operators Manual - Manual (Page 29)

Section 2: Overview 15
While the scroll bars are displayed and the control is not cutting, the view of the plate can be shifted
horizontally and vertically by holding down a shift key and pressing the arrow keys. While the control
is cutting, the view will automatically be shifted as the cut path reaches one of the edges of the view.
This mode is useful in normal cutting to closely follow the cut-path while in zoom.
View Sheet is more useful when proper Plate Size values have been entered in Cutting Setups.
Change Cut Mode
Allows selection of Trial, Oxy Fuel, Plasma, Waterjet and Laser cutting modes, depending on the
setup configuration. This softkey offers the selections of Automatic, Manual or Test Run for I/O type
“B” configured controls.
Change Consumable
This softkey takes you to the Change Consumable screen.
Zero Positions
This softkey zeros the current positions on the Transverse and Rail axes as well as the Dual Gantry
axis if used.