Hypertherm HTA Rev 6.00 Operators Manual - Manual (Page 77)

Section 4: Shape Manager 63
Using HyperNest – CNC ®
To begin, first select the plate size requirements for the nest at the Main Setup screen. Press the
Nester™ softkey from the Shape Manager Screen then enter the Setup Screen to enable the
Automatic Nesting software feature and configure the setup parameters for use. Press Done to
return to the Main Screen and begin placing parts in the nest.
Adding Parts
At the Main Screen, press the Add Part softkey to add a new part to the nesting part list. The Add
Part screen will allow the user to select a part from the Simple Shape Library, from a disk or from the
host computer via link communications.
Once a part has been selected from the desired location, the user will be prompted to select the
number of pieces desired.