Hypertherm HTA Rev 6.00 Operators Manual - Manual (Page 177)

Appendix A: Mariner™ & Voyager II™ 163
Maximum Ratio
The Automated Process monitoring uses sensors within the laser head to make adjustments
based on the ratio of the feedback from laser head sensors. The user sets the maximum and
minimum values for operation.
Minimum Ratio
The Automated Process monitoring uses sensors within the laser head and makes adjustments
based on the ratio of the feedback from these sensors. The user sets the maximum and
minimum values for operation.
Auto Adjust Speed
The Automated Process Monitoring controls the adjustments for speed of the operation. The
user selects how many times the Auto Adjust Speed process can automatically adjust.
Adjustment Delay
This sets the value for delays between process adjustments.
Over Combustion
This sets the value for detection of over combustion based on voltage from the laser head
sensors.
Loss of Cut
This sets the value for detection of over combustion based on voltage from the laser head
sensors.
Save Data
Pressing the Save Data softkey allows the user to save the current process settings to the Hard
drive creating a custom user database based on the eight process variables selected.
Process Defaults
Pressing the Process Defaults softkey allows the user to reset the current settings to factory
recommend factory defaults based on the eight process variables selected.
Save Database
Pressing the Save Database softkey allows the user to save the current User and Factory
databases to diskette. User files are designated with a .usr file extension and the factory files are
designated with a .fac file extension
Load Database
Pressing the load Database softkey allows the user to the factory default database files which are
supplied by Hypertherm in a Text file ( .txt ), user files ( .usr ) or factory files ( .fac ) from diskette.
Test Gas
Pressing the Test Gas softkey performs the Test Gases feature at the Laser supply.