Hypertherm HTA Rev 6.00 Operators Manual - Manual (Page 39)

Section 3: Setups 25
Section 3: Setups
Cutting
When entering the Setup menu the operator will be prompted for the following run-time parameters
for Trial Mode (no cutting), Oxy-Fuel, Plasma Waterjet and Laser cutting.
Plate Size
Specifies the dimensions of the current plate being cut. This dimension is used when loading a part
to determine if it will fit on the plate. It is also used for viewing the part in Screen View.
Cut Mode
Specifies the current cut mode. Trial/Test mode allows the operator to dry-run the current part
program without cutting. Press the left or right arrow keys to select the desired cut mode.
Trial/Cut Speed
Specifies the speed for the current cut mode. These speeds are saved independently for trialing and
cutting. Both speeds will be limited to the maximum machine speed. Cut and Trial speeds may be
executed at the embedded F-code speed within a part program.
Marker 1 / Marker 2 Speed
Specifies the speed for the selected Marker. These speeds are saved independently for each Marker
and are executed through the marker tool selection within a part program. Marker 1 is activated by
EIA RS-274D M09 and M10, or an ESSI 9 and 10. Marker 2 is activated by EIA RS-274D M013 and
M14, or an ESSI 13 and 14.