Hypertherm HTA Rev 6.00 Operators Manual - Manual (Page 181)

Appendix A: Mariner™ & Voyager II™ 167
HD4070 ® and HPR130™ Overview
The Mariner ™ and Voyager II™ controls offer the additional option of interfacing directly to
Hypertherm’s HD4070
® HyDefinition ® and HPR130™ Plasma Supplies for setup. This feature
has the ability to improve power supply setup and operational accuracy while having the flexibility
to fine tune the process specific to the operator’s needs.
When using this advanced feature, all necessary power supply settings are transmitted from the
control directly to the Plasma Supply configuring it for use via serial communications. The Plasma
Supply setup is performed through the use of a Cut Chart (cut process parameter database)
which is based on eight process variables. The combination of these eight process variables are
tied to the settings for the cut process parameters (e.g. arc voltage, pierce delay, etc.) that are
transmitted to the supply. For additional convenience, consumable part numbers for the Plasma
supply are displayed at the Change Consumable screen.
This database allows the user to select factory recommended settings or amend the database for
personalized settings. The Cut Chart information may be saved or loaded via the hard drive or
floppy drive. The Cut Chart files containing the factory recommended settings are available from
Hypertherm
® .
Access to the Cut Chart data is available from the Plasma Cut Types or Marker Cut Types screen
using the shift key, as indicated below. The Plasma Supply parameters must first be enabled in
the password protected Station Configuration setups to allow the Cut Chart Information for the
Plasma Supply to be available for use.
Example:
Note: Screen information will vary depending on THC selection.