Hypertherm HTA Rev 6.00 Operators Manual - Manual (Page 150)

136 Operator’s Manual
Volts per Minute
The Volts per Minute parameter allows the user to input a value that will be used to change the cut
Arc Voltage based on the number of minutes that have elapsed while cutting in Plasma mode. This
value will adjust the Voltage offset value. Note: This feature is only available for systems configured
with the Sensor™ THC.
Last Torch Tip Installed
Displays the date and time when the selected tip was installed.
Last Electrode Installed
Displays the date and time when the selected electrode was installed.
New Torch Tip
Pressing the New Torch Tip softkey allows the operator to select which Torch Tip has been replaced
and to update the database.
New Electrode
Pressing the New Electrode softkey allows the operator to select which Electrode has been replaced
and to update the database.
Setups
Pressing the Setups softkey accesses the control setups for adjustment of the cut process.
Reset Database
This softkey is used to reset the values in the database on the control, clearing the torch tip or
electrode information after uploading or saving the database.
Upload Database
This softkey is used to upload the current database to a host computer running our link.
Save Database
This softkey is used to save the current database to the diskette.