View and log nmea data, Nmea viewer setup, View nmea data – NavCom StarUtil Rev.G User Manual
Page 117: Log nmea data, Figure 114: nmea set to data port, Figure 115: nmea viewer, Figure 116: nmea logging, Messages (see figure 115, Figure 116), View and log nmea data for
StarUtil User Guide – Rev. G
View and Log NMEA Data
This section provides guidance to setup the NMEA viewer, and steps to view and/or log NMEA
message output.
NMEA Viewer Setup
To view and/or log NMEA message output, a second instance of
StarUtil must be run, and NMEA messages must be output from
the Data port. They cannot be output on the same port that is
used for Control.
If desired, the user m
Port
ay use any ASCII RS232 port viewer
instead of StarUtil.
Figure 114: NMEA Set To Data
View NMEA Data
9
Select Tools > NMEA Viewer from the menu bar. The viewer opens with data output from
the scheduled NMEA messages (see Figure 115).
Refer to
9
Figure 115: NMEA Viewer
Log NMEA Data
Figure 116 for the steps below:
Click the
button to create a log file. A window opens.
9
e NMEA.log file, if desired, and save it in a folder. The NMEA Viewer window
path.
9
Click the Start button to
p button to stop logging.
Rename th
displays the
begin logging the output data. Click the Sto
Figure 116: NMEA Logging
8-115