NavCom StarUtil Rev.G - Manual (Page 12)

StarUtil User Guide – Rev. G
x
Revision History
Rev G (Apr 2009)
Added a Note regarding message B0. (B0 at the default rate of On
Change is 1Hz regardless of the nav rate setting. To set the output of B0
at a higher rate to match the output of B1, use the NCT Binary Messages
window.)
Updated Figures 18 and 42 to show B0 set at 5Hz instead of On Change
in the NCT Binary Messages window, as an example of scheduling B0 to
a higher rate to match B1.
Added an updated StarFire Satellite table for Software v5.1.6 and later.
Indentified the original StarFire Satellite table as pertaining to Software
v4.2.26 and earlier.
Corrected the valid range for a Base site ID. The corrected range is
“1 to 1023”. The incorrect range was “0 to 1023”.
Added “Failed Search” section describing receiver functionality after a 5
minute failed search for a StarFire satellite.
Rev F (May 2008)
Updated guide to describe StarUtil-2000 & StarUtil-2100
Format change
Added Revision History