NavCom StarUtil Rev.G - Manual (Page 46)

StarUtil User Guide – Rev. G
Figure 35: Base Location –Self Survey
Refer to Figure 35 for the options below:
• Self Survey:
• Click the radio button next to Self Survey.
• Click
the Start Self Survey button to obtain a position from the received GPS signals.
‡
The time of survey varies and average position is used. For best results, allow
the receiver to run several hours (minimum of 10 minutes). Errors in the base
position will apply an equal bias error in the rover position.
• Click
the Stop Self Survey and Apply Position button to save the position in NVRAM.
‡
This sends the 0x51 message to the receiver, which contains only the averaged
base antenna location parameters.
12. Click the Apply button at the bottom of the window. Then click the OK button to exit.
‡
This sends the 0x50 message, and as appropriate, messages 0x56, 0x5A, and/or
0x5C to the base. The base is configured to send RTK corrections to the rover.
13. Go to the next section to verify that t he base is correctly configured.
5-44