Figure 66: port radio setting, Figure 67: radio configuration – operation mode, See figure 67) – NavCom StarUtil Rev.G User Manual
Page 70: See figure 66)
StarUtil User Guide – Rev. G
Figure 66: Port Radio Setting
2. Set the baud rate, as appropriate for data logging or NMEA output, for Port 1 (19200
default). Do not change the default parity (None).
3. Depending on configuration, set the logical port NCT RTK, RTCM, CMR.out, or CMR.in to
Port Radio (equivalent to Com1).
4. Click
the
Apply button and then click the Retrieve button to confirm that the receiver accepts
the settings.
5. Select
Receiver > Setup > Internal Radio > Settings. The Radio Configurations window
opens.
6. On
the
Operation Mode tab, select the mode
(see Figure 67):
• Base Station: 1 = Master, Point to
Multipoint
Or
dio Configuration – Operation Mode
tput power is limited by the license.
evel permitted by the country the unit is sold to. Select
• Rover: 3 = Slave (default)
Figure 67: Ra
7. Click
the
Power Level tab.
8. Select
the
Radio Power Level, typically 1000mW max (see Figure 68).
If the Radio Power Level is set to Off, the rover does not receive RTK
corrections. Ou
Some countries limit the output power to 100mW. NavCom typically limits the
maximum power to the l
the maximum licensed power level.
5-68