NavCom StarUtil Rev.G - Manual (Page 37)

StarUtil User Guide – Rev. G
elevation angle at which the receiver will start processing GPS data to be added to the
navigation solution.
Special Navigation Modes
9 Require dGPS for Solution: The default is No which
indicates that all computed position solutions are output
whether differentially corrected or not. Click the Yes button
to require only dGPS for solution.
Navigation Mode
9 RTCM-104 Input, WCT Input, SBAS
[WAAS/EGNOS/MSAS/GAGAN], and RTG Input: The
default for all the navigation modes is Use.
• Access
to RTG input is available only by purchase of a
license for the StarFire™ subscription service. Refer to
Chapter 6 StarFire™ Operation .
• WCT input is not applicable as of January 2008.
• Click
the Ignore button to disable a navigation mode.
orrections. Refer to the section below, WAAS Prn Selection, for
RTK Correction Format:
ult
, 5E) is the setting for the NavCom propriety RT
formats. Refer to the Technical Reference Manual
nts in the fore-matter).
MR+ corrections.
• Click
the Ignore button for all the navigation modes to
operate in non-differential mode.
Figure 24: Navigation Modes
‡
StarUtil provides the option to manually enter two L1 SBAS satellite Prns from
which to receive c
details.
9 RTK (5B, 5C, 5E), CMR Input, and RTCM RTK: The defa
• Click
the Use button to apply a RTK correction format to the navigation solution.
is Ignore All.
K and UltraRTK™
for details on messages 5B,
‡
RTK (5B, 5C
5C, and 5E (see Related Docume
‡
CMR Input enables the input of CMR or C
4-35