Teac HS-2 - Manual (Page 117)

TASCAM HS-2
117
If the operation of this unit becomes irregular, please
check the following things before requesting repair.
If the following measures do not resolve the problem,
contact the store where you purchased the device or a
TEAC Repair Center.
8 Power does not turn on.
Confirm that the power plug, for example, is connected
completely.
8 Media is not recognized.
• Confirm that the card is securely inserted into the card
slot.
• Pause recording or playback.
8 The unit controls do not function.
Is the panel lock function ON?
8 Playback is not possible.
Confirm that the audio file's sampling frequency
(44.1/48/88.2/96/176.4/192kHz) and quantization bit rate
(16/24) are compatible.
Confirm that the project and the sound file's sampling
frequency are consistent.
8 There is no sound.
• Reconfirm the connections of your monitoring system
and check the level of your amplifier.
• When using a TASCAM RC-HS20PD remote controller
(sold separately), confirm that the fader is not lowered.
• If you cannot hear the input signal, turn input
monitoring ON.
• If you cannot hear the playback sound, turn input
monitoring OFF.
8 Recording is not possible.
• Reconfirm connections.
• Adjust the recording levels.
• If the media storage device does not have sufficient
space, erase unneeded DATA to increase the amount of
available space or change the media storage device.
• If the maximum number of recordable takes or the
maximum take number has been reached, change the
recording session.
• If the total number of items in the folder, including files
and subfolders/directories, is too large, change the
recording session.
8 Setting changes are not remembered.
This unit backs up settings whenever the media storage
device selection is changed, a project, session or take is
loaded, and playback or recording occurs. After startup, if
none of these actions is conducted, settings might not be
backed up even if they are changed.
8 I hear noise.
Confirm that none of the cables have problems.
8 The touch panel does not work properly.
• Do not use commercially-available protective film for
LCD screens on the touch panel.
• Confirm that the panel lock function is not engaged
and locking the display.
8 I cannot create a new project.
• Confirm that a project with the same name does not
already exist.
• If the amount of space remaining on the media storage
device is insufficient, a new project cannot be created.
15–Troubleshooting