Teac HS-2 - Manual (Page 95)

TASCAM HS-2
95
Frame Type
Set the time code frame type of the currently loaded
project.
Setting buttons:
23.976F
,
24F
,
25F
,
29.97DF
(default),
29.97ND
,
30DF
,
30ND
I/O page
Set the synchronization signal status display and time
code output on this page.
NOTE
If the Option SY-2 has not been installed, the display is
shaded and the setting cannot be selected.
STATUS
This shows the status of synchronization signals.
TIMECODE IN:
When time code is input, the time code frame rate is
shown.
WORD/VIDEO IN:
When a synchronization signal is detected at this
connector,
WORD
,
VIDEO
or
TriLevel
is shown.
TC Out Mode
Use the buttons to set the time code output mode.
GenOut button:
Time code is output from the internal time code
generator.
PlayOut button (default):
In timeline mode, the time code time for playback and
recording is output. In take and playlist modes during
playback, the time code recorded in the file is output.
Remote settings (REMOTE SETUP)
Make settings for the PARALLEL, RS-232C, RS-422 and
Ethernet (Network) connectors.
The
REMOTE SETUP
screen has 5 pages:
GENERAL
,
PARALLEL
,
RS-232C
,
RS-422
and
ETHERNET
. Touch
the tabs at the bottom of the screen to open the corre-
sponding page.
GENERAL page
Make the external remote controller settings on this page.
FADER MODE
Allows the fader on an external TASCAM RC-HS20PD
remote controller (sold separately) to be enabled or
disabled. When set to
Disable
, the internal fader is fixed
at 0 dB.
Setting buttons:
Disable
,
Enable
(default)
FADER Start MODE
When the fader start function of an external TASCAM
RC-HS20PD remote controller (sold separately), for
example, is on, set whether fader starts, which allows
you to start playback by raising the fader from ∞ when in
playback standby, is enabled or not.
Setting buttons:
Disable
,
Enable
(Default)
FADER Stop MODE
When the fader start function of an external TASCAM
RC-HS20PD remote controller (sold separately), for
example, is on, set whether fader stop, which allows you
to put playback into standby by lowering the fader to ∞
during playback standby, is enabled or not.
Setting buttons:
Disable
,
Enable
(Default)
NOTE
If both the
FADER Start MODE
and
FADER Stop MODE
items are set to
Disable
, the fader start function of the
external TASCAM RC-HS20PD remote controller (sold
separately) will be turned off automatically, and the
FADER START indicator will turn off. In this state, if you
touch the Fader Start key on the TASCAM RC-HS20PD
remote controller, a “
Cannot Change Now. Fixed in
current mode
” warning appears in a pop-up window.
10–Internal settings