Teac HS-2 - Manual (Page 68)

68
TASCAM HS-2
Changing the start time of a take
1 Press the PROJECT key on the front panel to open
the
PROJECT
screen.
2 Touch the
e
button for the project that contains
the take for which you want to edit the start time
to open the session selection screen. If it is not the
current project, a pop-up window appears confirm-
ing that you want to load it. Touch the
OK
button.
3 Touch the e button for the session that contains
the take for which you want to edit the start time to
open the take selection screen. If it is not the cur-
rent session, a pop-up window appears confirming
that you want to load it. Touch the
OK
button.
NOTE
To load a take from the current session, instead of steps
2–3, touch the session name button at the top right of
the project screen or touch the take name button on the
Home Screen, and touch the
TAKE List
button in the
pull-down menu to open the take selection screen for the
current session.
4 Select the take that you want to edit the start time.
5 Touch the
MENU
button on the take selection screen
to open a pull-up menu.
6 Touch the
EDIT TC
button in the pull-up menu to
open the
TAKE TC
screen.
7 On the
TAKE T/C
screen, use the
FRAME EDIT
but-
ton to set whether or not to input the frame value.
Frame edit on
Frame edit off
8 Use the number buttons to input the take start
time.
• If you begin input without selecting a digit, input
will start from the smallest one.
• To input a specific digit, touch it to make its
background yellow, and then use the number
buttons or the DATA dial to enter two digits at a
time.
• Touch the CLEAR
button to erase all entered values.
9 Touch the
ENTER
button to confirm the setting.
TIP
• This can also be edited using an externally connected
keyboard.
• Press the keyboard’s ESC key to clear all the values.
10 When the confirmation pop-up window appears,
touch the
OK
button or press the DATA dial.
8–Take mode