Teac HS-2 - Manual (Page 72)

72
TASCAM HS-2
Dividing a take (Divide)
Divide a take into two at the specified position.
7$.(BE 7$.(BD 7$.(
7$.( 7$.(
7$.(
7$.(
1 Press the HOME key to display the Home Screen.
2 Move the timeline cursor to the position where you
want to divide.
3 Touch the
EDIT
button to display the pull-up menu.
Touch the
Divide
button on the pull-up menu.
4 When
-- Divide Mode --
is displayed to enter
the scrubbing mode, follow one of the procedures
below to find the exact division position.
• Turn the JOG/SHUTTLE dial
• Press the
m
/ ,key (one sample intervals)
• Press the m [ ] or , [ ] key while
pressing and holding the SHIFT key (1 ms intervals)
• Press the . [MARK . ] or / [MARK / ] key
while pressing and holding the SHIFT key (Moves to
the next mark point)
When the position is determined, touch the
Divide
button at the lower-left of the screen. To cancel
dividing, touch the
Cancel
button at the lower left of
the screen, or press the STOP or EXIT/CANCEL key.
If the file name given after divided already exists and
the take cannot be divided, the message
Cannot
Divide.
appears.
5 When dividing is complete, the Home Screen will
be displayed after the pop-up window is displayed.
NOTE
• The take name is given as follows after divided:
• First half : <Take name before divided>_a
• Second half : <Take name before divided>_b
• The first half and then the second half will be played in
order.
• The current take will be the second half.
• Takes that followed the current take before divided will
follow the second half.
• The total number of takes increases by one after
divided.
• If a mark point exists at the specified position of
division, it moves to the beginning of the second half.
NOTE
Example)
Take list: Scene001-T001 before division
Take list: Scene001-T001 after division
CAUTION
It is possible to divide a take already in use in the
timeline or playlist modes.
If you divide such a take, an error pop-up appears
when you attempt to play the corresponding region/
entry.
8–Take mode