Teac HS-2 - Manual (Page 94)

94
TASCAM HS-2
T/C page
Make settings related to time code on this page.
Set to free run
Set to jam sync (and free once)
NOTE
If the Option SY-2 has not been installed, the display is
shaded and the setting cannot be selected.
STATUS
This shows the time code generator mode of the unit and
the time code frame type of the currently loaded project.
GENERATOR
The top line shows the current time code generator.
The bottom line shows the user bits (
UB
).
Touch the
GENERATOR
item
EDIT
button or the user bits
(
UB
) display area to open the
T/C USER BITS
screen.
When the time code generator is in free run mode, touch
the
RESTART
button to reset the time code of the time
code generator to the start time.
TC IN
The top line shows the time of the input time code and
the frame type. The bottom line shows the user bits (
UB
)
of the input time code.
In
FREE RUN
mode, touch the
CAPTURE
button to capture
the current time code and set it as the time code of the
time code generator.
If the time code generator mode is
FREE ONCE
or
JAM
SYNC
, the capture status (
WAITING
) indicator lights green
when waiting for time code, and it turns off after time
code is captured.
START TIME
When you touch the
GENERATOR
item
RESTART
button,
the time when the time code restarts is shown.
Touch the
START TIME
item
EDIT
button or the
START
TIME
display area to open the
START TIME
screen.
SETUP page
Make settings related to the time code generator on this
page.
STATUS
This area shows the currently loaded project’s time code
frame type.
TC GEN MODE
Use the buttons to set the time code generator mode.
NOTE
If the Option SY-2 has not been installed, the display is
shaded and the setting cannot be selected.
FREE RUN button:
The time code generator runs on its own.
FREE ONCE button (default):
After the input time code is captured once, the unit
starts free run mode.
TIME OF DAY button:
If you conduct any of the following operations, the
time will be captured from the internal clock and
free run mode will start.
• Turn the power on
• Set
TC GEN MODE
to this mode
• Reset the internal clock
JAM SYNC button:
When time code is input, the unit synchronizes to it.
If time code input is interrupted, the unit enters free
run mode.
REGEN button:
The unit synchronizes to the input time code.
REC RUN button:
The time code generator only functions during
recording. At all other times, the time code
generator stops.
10–Internal settings