Teac HS-2 - Manual (Page 20)

20
TASCAM HS-2
i INPUT MONITOR button
Touch this button to open the button to turn the input
monitor ON/ OFF.
When ON, sound input through the assigned input
connector is always output from this unit.
o BOUNCE I/O button
Touch this button to open a pull-up menu for
bouncing.
Bounce button
Touch this button to bounce. In the following circum-
stances, this button appears gray and cannot be used.
• When both starting (IN) and ending (OUT) points
have not been set
• During playback or recording
SET IN button
Touch to set the current position as the bounce
starting (IN) point.
SET OUT button
Touch to set the current position as the bounce ending
(OUT) point.
CLEAR button
Touch to discard the currently set bounce starting (IN)
and ending (OUT) points.
(See “Bouncing” on page 63.)
p NEXT TAKE NAME button
Touch this button to open the
NEXT TAKE NAME
page
where you can set the name that will be given to takes
or files recorded in the future.
• First half of take names
The first half of the take name can be set to either
the
User Word
or the
Session Name
(default).
CAUTION
The first half of the take name can only be changed
when the unit is stopped.
• User Word
mode (button)
Use the user word for the first half of the take name.
Touch the
EDIT
button to open the screen where
you can change the user word. (This works the same
as the screen for editing project names.)
• Session Name
mode (button)
Use the session name as the first half of the take
name.
• Second half of take names
The second half of the take name is comprised of
one alphabetical letter and a three-digit number.
Touch the
EDIT
button to open the screen where
you can change the letter.
You can change the three-digit number with the +
and – buttons. You can also touch the numerical part
to highlight it in yellow and use the DATA dial to
change the number.
In the following cases, “
---
” appears and the value
cannot be changed.
• No project or session is loaded
• The selected card is unavailable
• When the numerical part of the file name of the
current take is 999
CAUTION
• The Next Take Name
setting is saved with each
project. If you change projects, the setting from the
loaded project is used.
• The numerical part of the second half of the take name
can be changed even during playback and recording.
(The first half of the take name and the letter in the
second half can only be changed when stopped.)
NOTE
If the first half of the take name or the letter in the
second half is different, a take that has the same three-
digit number in the second half can be created.
2−Names and functions of parts