Teac HS-2 - Manual (Page 48)

48
TASCAM HS-2
Playback in timeline mode
Project/session selection
1 Press the PROJECT key on the front panel to open
the
PROJECT
screen.
2 Touch the
e
button next to the project that you
want to play to open the session selection screen.
If it is not the current project, a pop-up window
appears confirming that you want to load it. Touch the
OK
button.
3 Touch a session name button to select that session.
4 Touch the
MENU
button to open a pull-up menu and
touch the
LOAD
button.
The “
Load selected Session?
” pop-up appears.
5 Touch the
OK
button.
When loading completes, the Home Screen opens.
Setting input monitoring
Turn input monitoring OFF when you are playing back. If
input monitoring is ON, sound from the input connectors
will be output through all the output connectors of this
unit.
1 Touch the
INPUT MONITOR
button on the Home
Screen to open a pull-up with the input monitoring
ON
/
OFF
button.
2 If input monitoring is on (
ON
button appears blue),
touch the
OFF
button to turn it off (
OFF
button ap-
pears blue).
Locate to the playback start position
Use the m [ ] and , [ ] keys, jump to a mark
or use the manual locate function to locate to the time
where you want to start playback
When time code synchronization is ON, playback will
occur at the input time code, so locating as described
above is not necessary.
Playback control in timeline mode
Press the PLAY key to start playback.
Press the PAUSE key to pause playback.
Press the PLAY key again to resume playback.
Press the STOP (RETAKE) key to stop playback.
Press the
. [MARK .
] key or
/ [MARK /
] key
to skip to the start of another region.
Press and hold the m [
] or , [ ] key to
search backward or forward.
Press the
. [MARK .
] or
/ [MARK /
] key while
pressing and holding the SHIFT key to move between
marks.
Press and hold the m [
] or , [ ] key while
pressing and holding the SHIFT key to search at high-
speed.
While pressing and holding the STOP key, press the
. [MARK .
] or
/ [MARK /
] key to skip to the
beginning of the first region recorded or the end of the
last region. (This only works with the front panel keys.)
NOTE
Playback functions can also be used through parallel
control.
Using the call function
Press the CALL (CHASE) key to locate to the point where
playback was last started from playback standby (call
point) and put the unit in playback standby mode.
7–Timeline mode