Teac HS-2 - Manual (Page 90)

90
TASCAM HS-2
• If the space on either of the media storage devices runs
out or an error occurs during recording with
Mirror
set, recording to the media storage device with no
space remaining or to the media storage device on
which an error has occurred will stop. Recording of the
current file to the other media storage device will stop.
However, recording to the next take as a new file will
start.
Then, the message and media storage device remaining
space display button will be shown as follows:
1
If either of the media storage devices has run out of
space
Media storage device remaining space button
2 If a recording error has occurred on either of the
media storage devices
Media storage device remaining space button
FILE FORMAT page
Make settings related to the file format.
Bit Length
Set the quantization bit rate for recording files using the
following buttons.
Setting buttons:
16bit
(default),
24bit
Max File Size
Set the maximum size for recording files using the
following buttons.
Setting buttons:
640MB
,
1GB
,
2GB
(default)
Pause Mode
Set whether or not to divide files when a recording is
paused using the following buttons.
Setting buttons:
SPLIT
(default),
NO SPLIT
OPTIONS page
Make settings related to the pre-recording and auto
markers.
PreREC Time
Turn this function ON or OFF and set the length of
pre-recording time. (Default:
OFF
)
When
PreREC Time
is
ON
, the signal input during
recording standby is captured by the built-in memory for
the set amount of time, allowing a maximum of 5 seconds
to be recorded before recording is started manually.
To set the pre–recording time, touch the knob, and adjust
the value using the DATA dial.
Setting range:
1
–
5
seconds (default:
2
seconds)
Auto Marker
Make settings related to auto markers.
Audio Over:
Use this to add markers when the set audio level is
exceeded.
Turn this function ON or OFF and set the detection
level. (Default:
OFF
)
To set the detection level, touch the knob, and
adjust the value using the DATA dial.
Setting options:
–0.20dB
(default),
–0.17dB
,
–0.13dB
,
–0.10dB
,
–0.06dB
,
–0.03dB
Settings made here are reflected in the
Over
Level
setting on the
METER SETUP
screen.
Time Interval:
Use this to add marks at fixed time intervals. Turn
this function ON or OFF and set the time interval.
(Default:
OFF
)
To set the time, touch the knob, and adjust the
value using the DATA dial. The range of setting
values is 1–10 minutes (default:
5
minutes).
Sync Unlock:
Use this to add a mark when synchronization with
the master clock is lost. Turn this function ON or
OFF. (Default:
OFF
)
PRE / REC / END:
Marks are attached automatically on the PREREC
start point/ recording start point/ recording end
point. Set the ON / OFF status of the functions.
(Default:
OFF
)
10–Internal settings