TA Triumph-Adler CX 8682 - Manual (Page 13)

INSTALLATIONS AND SETTINGS ON THE SERVER-PC
U1 Plot 13
standard, it is possible that the plotter controller will not be
identified.
• System memory:
Use a system memory with at least 256 MB RAM. With this
system memory, you can plot or scan the maximum drawing
size. However, a system memory of 512 MB RAM is
recommended if you wish to simultaneously plot and scan
drawings with maximum drawing size. Simultaneous
scanning and plotting of smaller formats also enables the
use of smaller system memory. Please ask your dealer or the
support technician for further information.
• Hard drive:
The hard drive should have at least 10 GB memory.
• Network interface/Configuration:
10/100 Base T Ethernet, the TCP/IP configuration is
necessary
• U1 Controller
• Monitor:
At least 1024 x 768 pixels resolution
U1 Kernel Driver installation
Start your PC. After installing the Controller Board, the
operating system automatically reports that new hardware has
been found and that assistant has been started for installation
of the kernel-driver: