TA Triumph-Adler CX 8682 - Manual (Page 96)

JOB EDITOR
96 U1 Plot
Attention: If you enter a larger value, you will obtain
a s m a l l e r drawing: The entry 1 equates to 0.25 %.
Example: if you enter 401, the drawing is reduced to
99.75 %.
• HPGL Font path:
This entry informs you in which folder the fonts are to be used
when printing HPGL files. The path is preselected.
• Dither mode / RTL: Here you can select grey value
patterns for bitmap graphics. You can choose between the grey
value patterns “symmetric pattern“ or “diffusion pattern“. Test
them and see which pattern best suits your graphic. To do this,
you have to reload the drawing in the File Viewer after each
change.
• Patternstyle:
There are four fill patterns that you can use to influence a vector
graphic.
“Round“ means that a certain colored area is filled with a
certain number of filled circles, which are given a certain
arrangement on the area, to achieve the intended color
saturation.
In “Random“ on the other hand a percentage of color
saturation is determined for the same colored area, which is
then converted into the necessary number of pixel, which are
randomly arranged over the area to achieve the intended color
saturation.
Which is why that when circle patterns are overlapped, the
covered areas can not be as clearly identified as if two random
patterns are overlapped. The recommended default setting is
therefore “random“, because you can achieve the best results.
As the “round“ setting has been installed as a standard to date,
this option has been retained of you do not see the need to print
the same drawings differently in future.
In addition, you can also select the grey value patterns
“symmetric pattern“ and “loadable pattern“. As the name
suggests, the „symmetric pattern“ produces a symmetrical grey