TA Triumph-Adler CX 8682 - Manual (Page 86)

JOB EDITOR
86 U1 Plot
• Enable Frame:
Activate the “Enable frame“ field if you want a stamp frame to
be printed. Three default settings can be set for the stamp
frame. Here too, the settings refer to the currently valid size unit,
which you can see in the status bar:
- Upper setting - stamp border: With the upper of the three
settings you set the distance of the stamp to the edge of the
drawing.
- Middle setting – Stamp content: The middle setting gives the
distance of the stamp content to the stamp frame.
- Lower setting. The lower setting is used to fix the thickness of
the stamp frame.
“Data“ tab
On the “Data“ tab the user specifies the stamp text and logo.
You can also alter the text and text attributes on this tab or even
change the logo: