TA Triumph-Adler DCC 2520 - Manual (Page 239)

Included Scanner Utilities
6-47
Job Accounting Setting
If Job Accounting is configured for the device, the Job code must be entered when using the device.
When Job Accounting is enabled, the job code sent by the computer is verified by the scanner.
Therefore, the Job Accounting code must be configured in TWAIN Source at the computer.
Registration method
1 Click the Scan. Setup button on the TWAIN Source main dialog box. The Scanner Setup dialog
box is shown.
2 Click the Edit button. The Address Setting dialog box is shown.
3 Click the Use Management Code check box to add a check mark.
4 To always use the same code, enter the desired Job code (8 digits or less) in the Code field.
5 Enter the same Job code entered into the Code field again in the Confirm Code field.
6 Click the OK button.
7 If a Job code is not configured, a Job code entry screen will be displayed during connection. Enter
the code to be used.
About Color Profiles
The color scanner provides color profiles to adjust color.
NOTE: The color profile data import method varies for every TWAIN-compliant software. Use the
color profile after carefully reading the manual included with your TWAIN-complaint software.
Selecting a color profile compatible with this device
1 Launch the Web browser software.
2 Enter the scanner IP address or hostname into the address bar and press Enter.
3 The Web page feature top page is displayed. The file name for the color profile compatible with this
this scanner is shown to the right of Profile in the main frame.
4 Next, use the color profile with the same name as that shown in Step 3, found in the CD included
with this scanner CD (Software Library) under the Color Profile folder.
Unable to Connect to Scanner
One of the following problems may be preventing scanner connection. Try again after confirming the
scanner operation panel.
• The machine is currently copying or operating in a mode other than Wait for Scan mode.
• Original has been loaded into the optional document processor before connecting TWAIN
Source to the scanner.