Panasonic TH-86EQ2W 85.6" 4K Digital Signage Display - Manual (Page 162)

162
English
USB memory
network settings
Using a USB memory device, the network setting can be
made for multiple displays.
■
About the setting
The following items in [Network settings] - [LAN
setup] can be set.
[IP address], [Subnet mask], [Gateway],
[Command port], [EAP]
Note
● [Network settings] - [LAN setup] - [DHCP] is set to
[Off].
● [Network settings] - [Network control] is set to [On].
● Make sure that [Network settings] - [USB memory
network settings] is set to [Permit].
If it is set to [Prohibit], network setting cannot be
made with this function. (see page 78)
● Once the network setting is done with USB memory
device, [Network settings] - [USB memory network
settings] is set to [Prohibit].
■
Supported device
● Commercially available USB memory devices are
supported. (Those with security functions are not
supported. Operation is not guaranteed.)
● USB memory devices other than those formatted in
FAT16 or FAT32 cannot be used.
● Up to 32 GB of USB memory in size are supported.
● Only single partition configuration is supported.
● Use a writable USB memory device.
Saving the LAN setting file to the
USB memory device
Create the following files, and save them to the USB
memory device.
File name: th-55eq2_network.sh
Setting Example
TH-55EQ2_LAN_SETTINGS
A:192.168.0.18
S:255.255.255.0
G:192.168.0.1
P:1024
I:ON
E:EAP-TLS
E_U:EAPUSER
E_P:eappassword
E_D:digitalcertificate.pfx
E_C:cacerficate.cer
TH-55EQ2_LAN_SETTINGS:
Fixed characters represent the model name. Be sure to
input as follows.
TH-(inch size)(Model name)_LAN_SETTINGS
A: Specifies the IP address.
S: Specifies the subnet mask.
G: Specifies the gateway address.
P: Specifies the port number to use for the command
control.
I: Setting this to [ON] can set individual IP addresses for
each main unit.
One IP address is assigned to each main unit in the
range that can be specified as an IP address.
E: Selects the EAP setting. Describe the setting referring
to the following.
• NONE
• PEAP(MS-CHAPv2)
• PEAP(GTC)
• EAP-TTLS(MD5)
• EAP-TTLS(MS-CHAPv2)
• EAP-FAST(MS-CHAPv2)
• EAP-FAST(GTC)
• EAP-TLS
E_U: Specifies the EAP user name. This is referred
to only when EAP is set to something other than
[NONE].
E_P: Specifies the EAP password. This is referred to
only when EAP is set to something other than
[NONE].
E_D: Describe the file name of the electronic certificate
(extension: PFX) used for authentication. This is
referred to only when EAP is set to [EAP-TLS].
E_C: Describe the file name of the CA certificate
(extension: CER) used for authentication. This is
referred to only when EAP is set to [EAP-TLS].