Panasonic TH-86EQ2W 85.6" 4K Digital Signage Display - Manual (Page 77)

77
English
■
[Network status]
Checks the current Network settings status.
192. 168. 0. 1
255. 255. 255. 0
192. 168. 0. 8
12:34:56:78:9A:BC
Network status
DHCP
IP address
Subnet mask
Gateway
EAP Off
None
MAC address
■
[DIGITAL LINK mode]
Switches communication method of DIGITAL LINK
terminal.
[Auto]:
Communication method is selected automatically.
HDMI, LAN, serial communication are possible.
Ethernet connection is possible.
[DIGITAL LINK]:
HDMI, LAN, serial communication are possible via a
twisted pair cable transmitter.
[Ethernet]:
LAN communication is performed.
[Long reach]:
Communication method is fixed to Long reach.
Modes allowing communication
: Valid
― : Invalid
Settings
Communication validity
Picture
transmission Ethernet RS-
232C
100 m 150 m
Auto
For
DIGITAL
LINK
―
For Long
reach
―
For
Ethernet
― ― ―
DIGITAL LINK ―
Long reach ―
Ethernet ― ― ―
Note
● When connected with the [Long reach]
communication method, the maximum
transmission distance is 150 m. In this case, this
unit can receive the signals of up to 1080/60p
(148.5 MHz).
● If the communication method of the twisted
pair cable transmitter is set to [Long reach], set
[DIGITAL LINK mode] to [Auto]. Then, connection
is enabled with the [Long reach] communication
method.
When connecting with the separately sold DIGITAL
LINK Switcher (ET-YFB200G) with the [Long
reach] communication method, set [DIGITAL LINK
mode] to [Long reach].
● Even if [DIGITAL LINK mode] is set to [Long
reach], when the twisted pair cable transmitter
does not support the communication method of
[Long reach], it will not be connected properly.
● When [LAN terminal setting] is set to [LAN
terminal], even if [DIGITAL LINK mode] is set to
[Ethernet], the Ethernet connection cannot be
made.
■
[DIGITAL LINK status]
Display the DIGITAL LINK connection environment.
Select [DIGITAL LINK status] with and press
<ENTER>.
-YY dB
-XX dB
DIGITAL LINK status
LINK status
HDMI status
Signal quality
Min
Max
No link
No HDMI
[LINK status]:
1 of the followings will be displayed.
[No link]:
No LAN connection, etc.
[DIGITAL LINK]:
Connected to the DIGITAL LINK device by LAN.
[Long reach]:
Communication method is set to [Long reach] and
is connected to the DIGITAL LINK device by LAN.
[Ethernet]:
The PC is connected to the DIGITAL LINK / LAN
terminal of this product and is LAN connected.
[HDMI status]:
Displays the connection status of the HDMI format.
1 of the followings will be displayed.
[No HDMI]:
DIGITAL LINK not connected
[HDMI on]:
DIGITAL LINK connected
[HDCP on]:
HDCP supported on DIGITAL LINK
[Signal quality]:
It is the quantified minimum and maximum numbers
of errors that have occurred. The display colours are
red, yellow, or blue, depending on the number.
Signal quality
Display
Colours
Reception
Status
-12dB or below Blue Good
-11 to -8dB Yellow Bad
-7dB or above Red Terrible
● The number is represented by yellow or red if
the LAN cable is disconnected or the cable is not
shielded.
● This signal quality shows figures between the
twisted pair cable transmitter that is connected and
the display.