Panasonic TH-86EQ2W 85.6" 4K Digital Signage Display - Manual (Page 171)

171
English
Troubleshooting
Before you call for service, determine the symptoms and make a few simple checks as shown below.
Symptoms Check
Picture Sound
Electrical Appliances
Cars / Motorcycles
Fluorescent light
Interference Noisy Sound
Volume
(Check whether the mute function has been activated on the remote
control.)
Normal Picture No Sound
Not plugged into AC outlet
Not switched on
Picture and Brightness/Volume setting
(Check by pressing the <Main Power On / Off button> or the <Standby
(ON/OFF) button>.) No Picture No Sound
If a signal with a non-applicable colour system format, or frequency is
input, only the input terminal indication is displayed.
No Picture Normal Sound
Colour controls set at minimum level (see page 46, 48)
No Colour Normal Sound
A display error such as “no picture”
occurs, or remote control operation is
suddenly disabled.
This unit incorporates highly-advanced software. If you notice an abnormal
operation such as “Remote control cannot be operated” or “Display is
disturbed”, remove the power plug from the socket outlet, and inset it again
after 5 seconds or more to turn the power on. (see page 33)
Power automatically turns off
unexpectedly.
Check the settings of [No signal power off], “Power management” function
for each input and [No activity power off]. Any of them may be set to [On
(Enable)]. (see page 61)
Power indicator is blinking in orange.
There is possibility of malfunction. Please contact an Authorized Service
Centre.
No remote control operations can be
performed.
Check whether the batteries have discharged completely and, if they have
not, whether they were inserted properly.
Check whether the remote control sensor is exposed to an outdoor light or
a strong fluorescent light.
Check whether any obstacle is present between the remote control sensor
and the remote control. (see page 30)
Check whether the remote control designed specifically for use with the
unit is being used. (The unit cannot be operated by any other remote
control.)
Check whether the option other than [Off] is selected in [Controller user
level]. (see page 88)
Check whether [Controller ID function] is set to [On]. (see page 85)
Check whether <ID MODE> switch is set to <ON>. (When using ID remote
controller) (see page 164)
[Controller ID function] function cannot
be used.
(When using ID remote controller)
Check whether [Controller ID function] is set to [On], or <ID MODE> switch
is set to <ON>. (see page 85)
(When [Controller ID function] is set to [On], you need to set <ID MODE>
switch to <ON> and set the ID number.)