Panasonic TH-86EQ2W 85.6" 4K Digital Signage Display - Manual (Page 84)

84
English
■
[OSD transparency]
Sets the transparency rate of the on-screen display
background.
0 to 100
■
[OSD memory]
Sets whether or not to hold the cursor position on the
menu screen.
[Off]:
The cursor position is not held.
[On]:
The cursor position is held.
Note
● Even if it is set to [On], if the power of the main unit is
turned off, the cursor position is not held.
Options
This menu displays the information of this unit, and
restores data to the factory default state.
[Options] - submenu screen
Display information
Options
Software licenses
Cloning password
USB data cloning
Security password
LAN data cloning
Output log data
Shipping
■
[Display information]
Displays the serial number, software version and use
time of this unit.
■
[Software licenses]
Displays the software license.
■
[Cloning password]
Sets the password for the cloning function.
For more detail of the settings, see “Changing the
cloning password”. (see page 161)
Note
● The initial password in the factory default state is
[AAAA].
● Change the password periodically, and set one which
is difficult to guess.
● For initialization method for the cloning password,
consult the dealer where you purchased the product.
■
[USB data cloning], [LAN data cloning]
Copies the data of a single display to multiple displays
by using the USB memory device or via LAN. For more
detail of the settings, see “Using data cloning”. (see
page 157)
■
[Output log data]
Saves a log for servicing to the USB memory device.
■
[Security password]
Set a password to protect the settings of this unit.
Security password
Security password
Save
Password ********
Off
[Security password]
[Off]:
Disables security password control.
[On]:
Enables security password control.
[Password]
The keyboard for setting the password is displayed. After
entering the password, select [Ok]; the confirmation
screen is displayed. Enter the password again and
select [Ok]; the password is determined.
● Entering characters (see page 165)
[Save]
Saves the settings above in the display unit.
Note
● The default password is “1111”.
● The security password is used when performing
[Shipping] and [Network settings] - [Reset].
● Change the password at a regular interval to make it
hard to be guessed.
● For how to initialize the security password, consult
your dealer.
■
[Shipping]
Restores the data of this unit to the factory default state.
For more detail of the settings, see “Shipping condition”.
(see page 169)
Control settings
Sets each item of the function which enables to control
multiple displays at the same time, or individually.
Note
● The DIGITAL LINK related menus are displayed
when the DIGITAL LINK Terminal Board is attached
to the expansion slot (SLOT).
[Control settings] - submenu screen
Control settings
Display ID
Controller ID function
Off
Serial ID function Off
0
Serial response (Normal) On
Serial response(ID all) Off
Serial ID group A
Serial response(ID group) Off
Serial daisy chain position ---
Serial control SERIAL IN