Efficient Networks 107-0001-000 - Manual (Page 140)

Chapter 5: Ethernet Interface Commands Efficient Networks ® Router family
Command Line Interface Guide
Page 5-2 Efficient Networks
®
eth ip addroute Adds a route to the default routing table for the
Ethernet interface.
eth ip addserver This Network Address Translation (NAT) com-
mand adds a server’s IP address (on the LAN) as-
sociated with this interface for a particular protocol.
eth ip bindroute Adds an Ethernet route to the named IP virtual
routing table.
eth ip defgateway Assigns an Ethernet default gateway for packets
whose destination address does not have a route
defined.
eth ip delhostmapping Undoes an IP address/ host translation (remap-
ping) range.
eth ip delroute Removes a route from the default routing table.
eth ip delserver Deletes a server entry.
eth ip directbcast Enables or disables the forwarding of broadcast
packets directed to a specific network prefix.
eth ip disable Disables IP routing across the Ethernet LAN.
eth ip enable Enables IP routing across the Ethernet LAN.
eth ip filter Manages the IP filters for the Ethernet interface(s).
eth ip firewall Enables and disables Ethernet Firewall Filtering.
eth ip mgmt Assigns to an Ethernet interface an IP address
which is to be used for management purposes only
and not for IP address translation.
eth ip options Enables or disables an IP option for the specified
Ethernet interface.
eth ip ripmulticast Changes the multicast address for RIP-1 compati-
ble and RIP-2 packets.
eth ip translate Controls Network Address Translation on a per-in-
terface basis.
eth ip unbindroute Removes an Ethernet route from the named IP vir-
tual routing table.
eth ip vrid Assigns a virtual router ID (VRID) to an Ethernet in-
terface.
Table 5-1: Ethernet Interface Command Listing (Cont.)
Command Function