Efficient Networks 107-0001-000 - Manual (Page 179)

Efficient Networks ® Router family
Command Line Interface Guide
Chapter 5: Ethernet Interface Commands
Efficient Networks
®
Page 5-41
eth vrrp clear password
Clears the password in a VRRP attribute record for the VRID (virtual router ID). To
see the current password, use the command
eth vrrp list . To set a new password, use
the command eth vrrp set password . For more information,see “ VRRP Backup” on
page 6-16 of the Technical Reference Guide.
NOTE:
If the VRRP attribute record has no password, no VRRP authentication is performed.
NOTE:
If you clear the password for one VRRP router, you must clear the password for every
router for that VRID on the LAN. For example, if VRID 7 is defined in routers A, B, and
C in the LAN and you clear the password for router A, you must clear the password for
routers B and C as well.
NOTE:
This command takes effect immediately, but changes must saved if it is to persist after
a restart the interface or reboot of the router.
Mgmt Class
Network (R/W)
Input Format
eth vrrp clear password <vrid> [<port#>]
Parameters
Example
This command example clears the password for VRID 7 using default port 0.
Response
Command prompt.
<vrid>
a
a
Integer, 1 - 255
Virtual router ID.
<port#>
b
b
The default is 0; the parameter may be omitted if the router has only one port.
Physical Ethernet interface (port) number.
-> eth clear password 7