Efficient Networks 107-0001-000 - Manual (Page 362)

Chapter 12: IKE/IPsec Commands Efficient Networks ® Router family
Command Line Interface Guide
Page 12-4 Efficient Networks
®
ipsec enable Enables a defined IPSec security association en-
try.
ipsec flush Clears all IPSec definitions.
ipsec list Lists one or all of the IPSec security association
(SA) entries.
ipsec set authentication Selects authentication for the IPSec SA using ei-
ther SHA-1 (Secure Hashing Algorithm 1) or MD5
(Message Digest 5).
ipsec set authkey Specifies the authentication key for the IPSec se-
curity authentication (SA).
ipsec set direction Defines the direction of the IPSec security authen-
tication (SA).
ipsec set compression Selects either LZ compression or no compression
for the IPSec security authentication (SA).
ipsec set enckey Specifies the encryption key for the IPSec security
authentication (SA).
ipsec set encryption Selects the method of encryption used for the IP-
Sec security authentication (SA): no encryption,
DES (56-bit) encryption, or 3DES (168-bit) encryp-
tion.
ipsec set gateway Defines the IP address of the IP gateway of the IP-
Sec security authentication (SA).
ipsec set ident Specifies the identifier (SPID) for the IPSec tunnel.
ipsec set mode Selects the encapsulation mode (tunnel or trans-
port) for the SA.
ipsec set service Selects the authentication and/or encryption ser-
vices used for the IPSec SA.
Table 12-1: Internet Key Exchange Command Listing (Cont.)
Command Function