Efficient Networks 107-0001-000 - Manual (Page 82)

Chapter 4: System Commands Efficient Networks ® Router family
Command Line Interface Guide
Page 4-12 Efficient Networks
®
system addsnmpfilter
Validates SNMP clients by defining a range of IP addresses that are allowed to
access the router via SNMP. This validation feature is off by default. This command is
functionally equivalent to the
snmp addsnmpfilter command.
NOTE:
This command does not require a reboot and is effective immediately.
NOTE:
To list the range of allowed clients, use the system list command. To delete addresses
from the SNMP filter, use the system delsnmpfilter or snmp delsnmpfilter command.
For more information, see ” Controlling Remote Management” on page 5-15 of the
Technical Reference Guide.
Mgmt Class
Security (R/W)
Input Format
system addsnmpfilter <first ip addr> [<last ip addr>] | lan
Parameters
Response
Command prompt.
<first ipaddr>
a
a Dotted-decimal notation
First IP address of the client range.
<last ipaddr> a Last IP address of the client range.
b
b May be omitted if the range contains only one IP address.
lan Local Ethernet LAN.