Efficient Networks 107-0001-000 - Manual (Page 96)

Chapter 4: System Commands Efficient Networks ® Router family
Command Line Interface Guide
Page 4-26 Efficient Networks
®
To see the current success rate values, use the system list command. For more
information about success rates and Dial Backup, see ” Ping Interval, Number of
Samples, and Success Rate” on page 6-13 of the Technical Reference Guide.
Mgmt Class
Network (R/W)
Input Format
system backup successrate <percentage> [<group>]
Parameters
Examples
The following command changes the success rate to 75% for addresses in group 0.
The following command disables the pinging of addresses in group 1.
Response
Command prompt.
system blocknetbiosdefault
The router can block all NetBIOS and NetBUI requests from being sent over the
WAN. This command sets the default value used when a remote router entry is
defined.
The command remote blocknetbios can change the NetBIOS setting for a specific
remote router. To see the current NetBIOS default, use the system list command.
Mgmt Class
Security (R/W)
<percentage>
a
a
Integer, 0 - 99 (50)
Minimum success rate required during a ping test of the addresses in
the group.
<minutes>
b
b
Integer, 0 - 65535 (0)
Optional, number of a group.
-> system backup successrate 75
-> system backup successrate 0 1