Efficient Networks 107-0001-000 - Manual (Page 232)

Chapter 6: Remote Commands Efficient Networks ® Router family
Command Line Interface Guide
Page 6-44 Efficient Networks
®
remote setbwthresh
Sets the bandwidth threshold for a DOD (dial on demand) connection, that is, a
connection where the link goes up and down. These links include those for ISDN,
L2TP tunnels, IPSec tunnels, and dial backup.
The threshold is used in bandwidth on demand management. Initially, a call is
activated on one B-channel. When bandwidth utilization reaches the bandwidth
threshold, the second B-channel is activated. (The additional channel is available if
the maximum links was set to 2 by a
remote setmaxline command.)
Both channel are utilized until the bandwidth utilization drops below the threshold. The
default is 0% utilization, in which case, both channels are always used for data
transmission.
If you wish, you can have the bandwidth threshold apply only to incoming or outgoing
traffic; see the
remote setbod command.
Mgmt Class
Voice (R/W)
Input Format
remote setBWthresh <threshold> <remotename>
Parameters
Response
Command prompt.
<threshold> Percentage of bandwidth utilization (0 through 100). The
default is 0, in which case, whenever data transmission
occurs, the maximum number of links is allocated.
<remotename>
a
a ASCII string
Name of the remote router.