Efficient Networks 107-0001-000 - Manual (Page 168)

Chapter 5: Ethernet Interface Commands Efficient Networks ® Router family
Command Line Interface Guide
Page 5-30 Efficient Networks
®
Parameters
Response
Command prompt.
eth ip translate
Controls Network Address Translation on a per-interface basis; it allows several PCs
to share a single IP address to the Internet. To read more about NAT, refer to
“
Network Address Translation (NAT)” on page 4-17 of the Technical Reference Guide.
Mgmt Class
Network (R/W)
Input Format
eth ip translate on | off | <interface>
Parameters
Examples
The following command enables Network Address Translation for port 0.
The following command disables Network Address Translation for logical interface
0:1.
Response
Command prompt.
<ip addr>
a
a
Dotted-decimal notation
IP address of the remote network or station.
on Indicates whether Network Address Translation is on or off for
this Ethernet interface.
off
<interface>
a,b
a
This parameter may be omitted if the router has only one Ethernet interface.
If the router has two physical Ethernet interfaces (an Ethernet hub router), the port number (0 or 1)
must be specified.
b To specify a logical interface other than logical interface 0, specify both the port number and the
logical interface number (<port #>:<logical #>, for example, 0:1).
Ethernet interface.
-> eth ip translate on
-> eth ip translate off 0:1