Efficient Networks 107-0001-000 - Manual (Page 394)

Chapter 12: IKE/IPsec Commands Efficient Networks ® Router family
Command Line Interface Guide
Page 12-36 Efficient Networks
®
ike peers set mode
Sets the IKE peer connection mode to either main mode or aggressive mode. Main
mode is used when the IP addresses of both ends are known and constant.
Aggressive mode is used when the address of one end can change, as with a typical
modem or DSL connection. (See “
Main Mode and Aggressive Mode” on page 5-54. )
Mgmt Class
Security (R/W)
Input Format
ike peers set mode <main | aggressive> <peername>
Parameters
Example
Response
Command prompt.
Choose one of the following:
main Select main mode (both ends constant).
aggressive Selects aggressive mode (one end can change).
<peername>
a
a
ASCII string
Name of the IKE peer whose mode is specified.
b
b To see the peer names, use the ike peers list command.
-> ike peers set mode aggressive my_aggressive_peer