Efficient Networks 107-0001-000 - Manual (Page 85)

Efficient Networks ® Router family
Command Line Interface Guide
Chapter 4: System Commands
Efficient Networks
®
Page 4-15
system addtelnetfilter
Validates Telnet clients by defining a range of IP addresses that are allowed to access
the router via Telnet. The mode is off by default. For more information, refer to
”
Controlling Remote Management” on page 5-15 of the Technical Reference Guide.
NOTE:
This command does not require a reboot and is effective immediately.
NOTE:
To list the range of allowed clients, use the system list command. To delete addresses
from the Telnet filter, use the system deltelnetfilter command.
Mgmt Class
Security (R/W)
Input Format
system addtelnetfilter <first ip addr> [<last ip addr>] | lan
Parameters
Response
Command prompt.
<first ipaddr>
a
a
Dotted-decimal notation
First IP address of the client range.
<last ipaddr> a Last IP address of the client range.
b
b May be omitted if the range contains only one IP address.
lan Local Ethernet LAN.