Efficient Networks 107-0001-000 - Manual (Page 90)

Chapter 4: System Commands Efficient Networks ® Router family
Command Line Interface Guide
Page 4-20 Efficient Networks
®
The following command clears all addresses from the list.
Response
Command prompt.
system backup disable
Disables the Dial Backup option in the router.
NOTE:
Because Dial Backup uses the console port, you cannot access the command line via
the console port while Dial Backup is enabled. You must use the Web GUI interface or
a Telnet session to disable Dial Backup.
NOTE:
If you do not use the save command to save this change, Dial Backup is only
temporarily disabled and it is re-enabled at the next reboot. Temporarily disabling Dial
Backup stops Dial Backup, but it does not change the use of the console port. To
disable Dial Backup across reboots, see ”
Disabling and Re-Enabling Dial Backup” on
page 6-15 of the Technical Reference Guide.
To re-enable the Dial Backup option, use the system backup enable command. For
more information about Dial Backup, refer to ” Dial Backup” on page 6-7 of the
Technical Reference Guide.
Mgmt Class
Network (R/W)
Input Format
system backup disable
Parameters
None
Response
Command prompt.
-> system backup delete all all