Efficient Networks 107-0001-000 - Manual (Page 273)

Efficient Networks ® Router family
Command Line Interface Guide
Chapter 7: WAN Interface Commands
Efficient Networks
®
Page 7-13
Dual-Ethernet Router (ETH) Commands
The following Ethernet commands are used to manage the Ethernet interfaces of the
Dual-Ethernet (Ethernet-to-Ethernet) router and thus are specific to that type of router
only. For the other Ethernet commands, see
Chapter 5, Ethernet Interface
Commands .
The Dual-Ethernet router has two interfaces:
• ETH/0Hub with four 10Base-T connectors
• ETH/1Single 10Base-T connector
This Dual-Ethernet router may be configured via the Web Browser GUI or from the
Command Line Interface (CLI). To set up any DHCP options and to configure optional
features like IP filtering, you must use the CLI.
If using the Boot from Network option from the boot menu to perform a boot code
update, the boot request is sent from the ETH/0 interface only.
The Dual-Ethernet Router commands found in this section include:
Table 7-4: Dual Ethernet Router Command Listing
Command Function
eth br enable Enables bridging in a Dual-Ethernet environment.
eth br disable Disables bridging in a Dual-Ethernet environment.
eth br options Sets controls on bridging for the Ethernet interface.