Efficient Networks 107-0001-000 - Manual (Page 80)

Chapter 4: System Commands Efficient Networks ® Router family
Command Line Interface Guide
Page 4-10 Efficient Networks
®
Response
Example
The following command defines a virtual routing table named ROSA (if it does not
already exist) and assigns it the IP address range 192.168.1.5 through 192.168.1.12.
After routing table ROSA has been defined, the following line appears in the output for
the command
system list :
system addserver
This Network Address Translation (NAT) command is used to configure a local IP
address as the selected server on the LAN (FTP, SMTP, etc.) for the global
configuration. To learn more, see ”
Network Address Translation (NAT)” on page 4-17
of the Technical Reference Guide.
Multiple system addserver , remote addserver , and eth ip addserver commands can
designate different servers for different protocols, ports, and interfaces. When a
request is received, the router searches the server list for the appropriate server. The
order of search for a server is discussed in ”
Server Request Hierarchy” on page 4-22
of the Technical Reference Guide.
To delete a server designation, use the system delserver command.
Mgmt Class
Network (R/W)
Input Format
system addserver <action> <protocol> <first port> [<last port>
[<first private port>]]
Response
Command prompt.
-> system addiproutingtable 192.168.1.5 192.168.1.12 ROSA
192.168.1.5 through 192.168.1.12 uses IP Routing Table <ROSA>