Efficient Networks 107-0001-000 - Manual (Page 213)

Efficient Networks ® Router family
Command Line Interface Guide
Chapter 6: Remote Commands
Efficient Networks
®
Page 6-25
remote disable
Disables the remote. The remote remains disabled even after a reboot. To enable the
remote, the command
remote enable must be entered.
NOTE:
You may enter and save information and settings for a disabled remote entry.
However, the remote entry cannot be used until it is enabled.
NOTE:
If the remote is currently active when the remote is disabled, the active session is not
stopped. To stop the active session, use the
remote stop command.
Mgmt Class
Network (R/W)
Input Format
remote disable <remotename>
Parameters
Response
Command prompt.
remote disauthen
This command is intended for situations where third-party routers cannot be
authenticated; the target router will not attempt to authenticate the remote router.
Mgmt Class
Security (R/W)
Input Format
remote disauthen <remotename>
<remotename>
a
a
ASCII string
Name of the remote router.