Ipsec set gateway, Mgmt class, Input format – Efficient Networks 107-0001-000 User Manual
Page 412: Parameters, Example, Response, Ipsec set ident, Ipsec set gateway -54, Ipsec set ident -54
Chapter 12: IKE/IPsec Commands
Page 12-54
Efficient Networks
®
ipsec set gateway
Defines the IP address of the IP gateway of the IPSec SA.
Mgmt Class
Security (R/W)
Input Format
ipsec set gateway <ipaddress> <saname>
Parameters
Example
Response
Command prompt.
ipsec set ident
Specifies the identifier (SPID) for the IPSec tunnel. It must match the SPID at the
other end of the tunnel, that is, the tx SPID on this end must match the rx SPID on the
other end.
Mgmt Class
Security (R/W)
Input Format
ipsec set ident <ident> <saname>
<ipaddress>
a
a
Dotted-decimal notation.
IP address of the IP gateway.
<saname>
b
b
ASCII string
Name of the IPSec SA to which the gateway parameter is added.
c
c
To see the IPSec SA names in use, use the
command.
-> ipsec set gateway 207.135.89.233 show_rx