Siemens MC55 - Manual (Page 104)

MC55 AT Command Set
5.1 AT+CPIN
s
m
obile
MC55_ATC_V01.05 Page 104 of 469 2/10/04
Confidential / Released
If no PIN request is pending (for example if PIN authentication has been done and the same PIN is entered again)
ME responds +CME ERROR: operation not allowed. No action is required from your part.
Parameter Description
Password (string type), usually SIM PIN1.
If the requested password was a PUK, such as SIM PUK1 or PH-SIM PUK or PH-FSIM PUK or another pass-
word, then
<pin>
must be followed by
<new pin>
.
if the requested code was a PUK: specify a new password or restore the former disabled password. See 5.1.1
for more information about when you may need to enter the PUK.
SIM PIN authentication
READY PIN has already been entered. No further entry needed.
SIM PIN ME is waiting for SIM PIN1.
SIM PUK ME is waiting for SIM PUK1 if PIN1 was disabled after three failed attempts to
enter PIN1.
SIM PIN2 ME is waiting for PIN2, when the attempt to access PIN2 requiring features was
acknowledged with +CME ERROR:17 (e.g. if client attempts to edit the FD
phonebook). This is only applicable if the AT+CPIN read command also
prompts for SIM PIN2. Normally, the AT+CPIN2 command is intended for SIM
PIN2.
SIM PUK2 ME is waiting for PUK2 to unblock a disabled PIN2. Necessary if preceding
command was acknowledged with error +CME ERROR:18 and only if the
AT+CPIN read command also prompts for SIM PUK2. Normally, the
AT+CPIN2 command is intended for SIM PUK2.
Phone security locks set by client or factory
PH-SIM PIN ME is waiting for phone-to-SIM card password if "PS" lock is active and user
inserts other SIM card than the one used for the lock. ("PS" lock is also referred
to as phone or antitheft lock).
PH-SIM PUK ME is waiting for Master Phone Code, if the above "PS" lock password was
incorrectly en-tered three times.
PH-FSIM PIN ME is waiting for phone-to-very-first-SIM card. Necessary when "PF" lock was
set. When powered up the first time, ME locks itself to the first SIM card put into
the card holder. As a result, operation of the mobile is restricted to this one SIM
card (unless the PH-FSIM PUK is used as described below).
PH-FSIM PUK ME is waiting for phone-to-very-first-SIM card unblocking password to be
given. Necessary when "PF" lock is active and other than first SIM card is
inserted.
PH-NET PIN ME is waiting for network personalisation password
PH-NET PUK ME is waiting for network personalisation unblocking password
PH-NS PIN ME is waiting for network subset personalisation password
PH-NS PUK ME is waiting for network subset unblocking password
PH-SP PIN ME is waiting for service provider personalisation password
<pin>
(str)
<new pin>
(text)
<code>
(text)