Siemens MC55 - Manual (Page 437)

MC55 AT Command Set
17.6 AT^SSYNC
s
m
obile
MC55_ATC_V01.05 Page 437 of 469 2/10/04
Confidential / Released
17.6 AT^SSYNC Configure SYNC Pin
The
AT^SSYNC
command serves to configure the SYNC pin of the application interface. Please note that the
SYNC pin may be assigned different functions: Depending on the design of the host application, the pin can
either be used to indicate the current consumption in a transmit burst or to drive a status LED connected to the
pin as specified in
[2] . For detailed information on the SYNC pin and its LED functionality refer to [2] . Before
changing the mode of the SYNC pin, carefully read the technical specifications.
Syntax
Parameter Description
[0] SYNC mode:
Enables the SYNC pin to indicate growing power consumption during a trans-
mit burst. You can make use of the signal generated by the SYNC pin, if power
consumption is your concern. To do so, ensure that your application is capable
Test Command
AT^SSYNC=?
Response(s)
^SSYNC:
list of supported
<mode>
s
OK
Read Command
AT^SSYNC?
Response(s)
^SSYNC: <mode>
OK
Write Command
AT^SSYNC= <mode>
Response(s)
OK
PIN ASC0 ASC1 MUX1 MUX2 MUX3
! % % % % %
Reference(s)
SIEMENS
<mode>
(num)