Siemens MC55 - Manual (Page 196)

MC55 AT Command Set
8.5 AT^SMONC
s
m
obile
MC55_ATC_V01.05 Page 196 of 469 2/10/04
Confidential / Released
Location area code
4 digits, e.g. 3010
0000 not decoded
Cell identifier
4 hexadecimal digits, e.g. 4EAF
0000 not decoded
Base station identity code
2 digits, e.g. 32
00 not decoded
ARFCN (Absolute Frequency Channel Number)
0 not decoded. In this case, all remaining parameters related to the same chan-
nel are neither decoded. For example, a non-existing cell appears as follows:
000,000,0000,0000,00,0,0,-,-
Received signal level of the BCCH carrier (0..63). The indicated value is composed of the measured value in
dBm plus an offset. This is in accordance with a formula specified in 3GPP TS 05.08
Coefficient for base station reselection, e.g. 30. In dedicated mode, under certain conditions the parameter can-
not be updated. In such cases a '-' is presented.
Coefficient for base station reselection, e.g. 30. In dedicated mode, under certain conditions the parameter can-
not be updated. In such cases a '-' is presented.
Note
• To some extent, the cell monitoring commands
AT^MONI
,
AT^MONP
and
AT^SMONC
cover the same param-
eters. The receiving level, for example, can be queried with all three commands. Yet the resulting values may
be slightly different, even though obtained over a time period of a few seconds. This is quite normal and noth-
ing to worry about, as the cell information is permanently updated.
<LAC>
(num)
<cell>
(num)
<BSIC>
(num)
<chann>
(num)
<RSSI>
(num)
<C1>
(num)
<C2>
(num)