Siemens MC55 - Manual (Page 428)

MC55 AT Command Set
17.1 AT+CALA
s
m
obile
MC55_ATC_V01.05 Page 428 of 469 2/10/04
Confidential / Released
EXAMPLE 2
To set a fresh alarm using the same message as in Example 1, simply enter date and time.
<n>
,
<type>
,
<text>
,
<tlength>
can be omitted:
When the alarm is executed the URC comes with the same message:
EXAMPLE 3
To configure the alarm mode, e.g. for May 20, 2004, at 8.30h, enter
Next, power down the ME:
When the alarm is executed the ME wakes up to Alarm mode and displays a URC. If available, this line is
followed by the individual
<text>
most recently saved. If no individual message was saved only the first line
appears.
17.1.1 Summary of AT commands available in Alarm mode
Table 17.1: List of AT Commands Available in Alarm and Charge-only Mode>
AT+CALA="04/05/31,08:50:00"
OK
+CALA: Good Morning
AT+CALA="04/05/20,08:30:00"
OK
AT^SMSO
^SMSO: MS OFF
^SYSSTART ALARM MODE
+CALA: Good Morning
AT command Use
AT+CALA
Set alarm time
AT+CCLK
Set date and time of RTC
AT^SBC
In Alarm mode, you can query the present current consumption only and check
whether or not a charger is connected. The battery capacity is returned as 0,
regardless of the actual voltage (since the values measured directly on the cell are
not delivered to the module).
AT^SCTM
Query temperature of GSM engine
AT^SMSO
Power down GSM engine