Siemens MC55 - Manual (Page 118)

MC55 AT Command Set
5.4 AT+CLCK
s
m
obile
MC55_ATC_V01.05 Page 118 of 469 2/10/04
Confidential / Released
0 lock is inactive
1 lock is active
Password string used to lock and to unlock a
<facility>
. Length and authority for passwords depend on the
<facility>
in question and are therefore listed in the section on parameter
<facility>
. Passwords can be
modified with
AT+CPWD
or
AT^SPWD
.
Integer or sum of integers each representing a class of information, i.e. a bearer service, telecommunication ser-
vice or bearer service group as defined in "GSM 02.04".
1 voice
2 class 2 ("data") comprises all those individual data classes between 16 and
128, that are supported both by the network and the MS. This means, a setting
made for class 2 applies to all individual data classes (if supported). In addition,
you can assign a different setting to a specific class. For example, you can acti-
vate Call Forwarding for all data classes, but deactivate it for data class 64,
"dedicated packet access".
4 fax
8 SMS
16 data circuit sync
32 data circuit async
64 dedicated packet access
128 dedicated PAD access
1...[7]...255 combination of some of the above classes.
For example, the default setting 7 represents the sum of the integers 1, 2 and
4 (voice, data and fax).
The value 255 covers all classes.
If parameter "class" is omitted, the default value 7 is used.
Notes
• The AT+CLCK command offers the full range of
<class>
parameters according to the GSM specifications.
However, when you attempt to use a service option which is not provisioned or not yet subscribed to, the set-
ting will not take effect regardless of the response returned.
The responses in these cases vary with the network (for example "OK", "Operation not allowed", "Operation
not supported" etc.). To make sure check the extended error response with
AT+CEER
and the lock status with
<mode>
=2.
• The command has been implemented with the full set of
<class>
parameters according to GSM 07.07. For
actual applicability of a desired Call barring service to a specific service or service group (a specific
<class>
value) please consult table A.1 of GSM 02.04.
• If an outgoing Fax or Data Call is rejected due to an active ''call barring'' supplementary service, the call will
be terminated with result code NO CARRIER.
Under the same conditions, an outgoing Voice call will be terminated with result code NO DIALTONE.
<status>
(num)
<password>
(str)
<class>
(num)