Siemens MC55 - Manual (Page 30)

MC55 AT Command Set
2. Configuration Commands
s
m
obile
MC55_ATC_V01.05 Page 30 of 469 2/10/04
Confidential / Released
2. Configuration Commands
The AT Commands described in this chapter allow the external application to determine the MC55's behaviour
under various conditions.
2.1 AT&F Set all current parameters to manufacturer defaults
Syntax
Command Description
TA sets all current parameters to the manufacturer defined profile.
Parameter Description
[0] set all TA parameters to manufacturer defaults
Notes
• List of parameters reset to manufacturer default can be found in Chapter
Factory Default Settings
Restorable with AT&F
.
• In addition to the default profile, you can store an individual one with
AT&W
. To alternate between the two pro-
files enter either
ATZ
(loads user profile) or
AT&F
(restores factory profile).
• Every ongoing or incoming call will be terminated.
Exec Command
AT&F
[
<value>
]
Response(s)
OK
PIN ASC0 ASC1 MUX1 MUX2 MUX3
! % % % % %
Reference(s)
V.25ter
<value>
(num)