Siemens MC55 - Manual (Page 153)

MC55 AT Command Set
7.11 ATS0
s
m
obile
MC55_ATC_V01.05 Page 153 of 469 2/10/04
Confidential / Released
7.11 ATS0 Set number of rings before automatically answering the
call
Syntax
Command Description
This parameter setting determines the number of rings before automatic answering.
Parameter Description
000 (&F) automatic answering is disabled
001-255 enable automatic answering on the specified ring number
Notes
• This command works for MT data and fax calls.
• Autoanswering of CSD data and fax calls is supported on ASC0/Mux1 only.
• A CSD call will not be answered automatically if the module is in GPRS online mode. However, this is possible
in GPRS command mode. The application can detect a call by evaluating the RING line and distinguish to
change into GPRS command Mode or stay in GPRS Online mode until GPRS is available again. To answer,
to reject or to wait for automatic anwsering the incoming call the application has to switch into GPRS com-
mand mode.
• If
<n>
is set to higher values, the calling party may terminate the call establishment before the call can be
automatically answered.
Read Command
ATS0?
Response(s)
<n>
OK
Write Command
ATS0= <n>
Response(s)
OK
PIN ASC0 ASC1 MUX1 MUX2 MUX3
§ % % % % %
Reference(s)
V.25ter
<n>
(num)(&W)(&V)