5 at+cgdata enter data state, At+cgdata, Obile – Siemens MC55 User Manual

Page 251: Mc55 at command set

Advertising

MC55 AT Command Set

10.5 AT+CGDATA

obile

MC55_ATC_V01.05

Page 251 of 469

2/10/04

Confidential / Released

10.5

AT+CGDATA Enter data state

Syntax

Command Description

The test command is used for requesting information on the supported layer 2 protocols to be used between the
TE and MT.

The write command causes the MT to perform all actions which are necessary to establish communication
between the TE and the network using one or more GPRS PDP types. This may include performing a GPRS
attach and one or more PDP context activations. Commands following the

AT+CGDATA

command in the AT com-

mand line will not be processed by the MT.
If no

<cid>

is given or if there is no matching context definition, the MT will attempt to activate the context with

PDP type IP and all other context parameters set to their default values (see

If the

parameter is omitted, the layer 2 protocol is unspecified and PPP will be used.

If the write command is successful, the MT issues the intermediate result code CONNECT and enters V.25ter
online data state.
After data transfer is complete, and the layer 2 protocol termination procedure has completed successfully, the
command state is reentered and the MT returns the final result code OK.
If the

<L2P>

parameter value is unacceptable to the MT, the MT returns ERROR or +CME ERROR.

In the event of erroneous termination or a failure to start up, the command state is reentered and the MT returns
NO CARRIER, or if enabled +CME ERROR.

Test Command

AT+CGDATA=?

Response(s)

+CGDATA:

(list of supported

<L2P>

Write Command

AT+CGDATA=

[

<L2P>

<cid>

[,... ]]]]