Siemens MC55 - Manual (Page 413)

MC55 AT Command Set
16.15 AT^SNFS
s
m
obile
MC55_ATC_V01.05 Page 413 of 469 2/10/04
Confidential / Released
16.15 AT^SNFS Select audio hardware set
Syntax
Command Description
The write command serves to set the audio mode required for the connected equipment. For use after restart of
the module, you are advised to store the selected mode to the audio profile set with
AT^SNFW
. Otherwise, audio
mode 1 will be active each time the module is powered up.
AT^SNFS
can also be used in conjunction with
AT^SAIC
. This is useful, for example, if both interfaces are oper-
ated alternatively to benefit from different devices. Each audio mode can be assigned a specific interface. To do
so, first select the audio mode with
AT^SNFS
, then activate the audio interface with
AT^SAIC
and finally enter
AT^SNFW
to store the settings to your audio profile. To switch back and forth it is sufficient to use
AT^SNFS
.
Test Command
AT^SNFS=?
Response(s)
^SNFS:
(list of supported
<audMode>
s)
OK
Read Command
AT^SNFS?
Response(s)
^SNFS: <audMode>
OK
Write Command
AT^SNFS= <audMode>
Response(s)
OK
ERROR
CME ERROR: <err>
PIN ASC0 ASC1 MUX1 MUX2 MUX3
! % % % % %
Reference(s)
SIEMENS